500 MmWC Heat Transfer Lab

Measuring pressure is important in the engineering industry, e.g. in plant, turbomachine and aircraft construction and in process engineering. Other fundamental factors such as flow rate or flow velocity can also be determined based on a pressure measurement.
The experimental unit enables the user to measure the pressure with two different measuring methods: directly by measuring the length of a liquid column (U-tube manometer, inclined tube manometer) and indirectly by measuring the change of shape of a Bourdon tube ( Bourdon tube pressure gauge).
In a tube, the pressure causes the liquid column to move. The pressure difference is read directly from a scale and is the measure for the applied pressure. In inclined tube manometers, one leg points diagonally up. Changes the length of the liquid column significantly.
The principle of the Bourdon tube pressure gauge is based on the change in cross-section of the bent Bourdon tube under pressure. This change in cross-section leads to an expansion of the Bourdon tube diameter. A Bourdon tube pressure gauge is therefore an indirectly Acting pressure gauge where the pressure differential is indicated via a transmission gearing and a pointer.
In experiments, pressures in the millibar range are generated with a plastic syringe and displayed on the manometers. The experimental unit is equipped with two Bourdon tube pressure gauges for measuring positive and negative pressure. The U-tube manometer, inclined tube manometer and Bourdon tube Pressure gauges at the experimental unit can be combined using tubes. A calibration device enables calibration of an additional Bourdon tube pressure gauge using a weight-loaded piston manometer.
Technical details
Basic experiments for measuring pressure with three different measuring instruments
U-tube and inclined tube manometer
One Bourdon tube pressure gauge each for positive and negative pressure
Plastic syringe generate test pressures in the millibar range
Calibration device with Bourdon tube pressure gauge for calibrating mechanical manometers
Technical data
Inclined tube manometer
Angle: 30°
Measuring ranges
Pressure:
0...±60mbar (Bourdon tube pressure gauge)
0...500mmWC (U-tube manometer)
0...500mmWC (inclined tube manometer)