Quality Assured
Worldwide Shipping
Expert Support
Automatic Wire Bending Machine 180 Degree Bending Test Equipment 500kn Electric Tensile Bending Testing Machine
Description & Specification
Automatic Wire Bending Machine 180 Degree Bending Test Equipment 500kn Electric Tensile Bending Testing Machine
Categories:
Wire Cable Test Machine
Technical Specifications
This is carried out tens of thousands of times in order to test the stability of the material. At the same time the test voltage is connected to the cable wires who are monitored for cable breaks by a special circuit. If the cable breaks, the system will shut down and the number of completed cycles is displayed on an integrated counter. In this equipment, the test sample is clamped in position and then flexed in a defined angle and at a defined speed. This tester is suitable for the bending testing of the multi-wires cable, communication cable, earphone cable etc.
Specifications:
Drive mode: servo motor
Test station: 6 station, can test six sample at the same time, independent control
Bending radius: 12.7mm, 25.4mm, 50.8mm, spacing adjustable
Distance between Anti-swing rod and fixture: 100~350mm adjustable
Distance of weight clamp to mandrels: ≥10cm
Test angle: ±(30°~180°)Adjustable
Angle resolution: 1°
Test speed: 10~60 cycle / min, adjustable
Load weight: 50g~1500g standard weight, total 6 sets.
Test clamp: A set/station, total 6 sets
Counter: 1~999999,auto stop when reached set value. Keep function for outage, 6 counter independent counting.
Power: AC220V,50HZ,10A.
