PLC Electro Hydraulic Trainer Kit

It‘s suitable for schools, engineer training centers, factory training department etc.
Through this trainer, students can master hydraulic components structure, hydraulic circuit control theory, hydraulic circuit design, and hand on ability for hydraulic trainer.
This trainer is flexible and students can design their own hydraulic circuit.
Technical parameter
DC power: input AC 380V,50Hz Output: DC 24V/3A
Wheel: 4, 2 lockable with brake, 2 not lockable
Hydraulic station:
nominal volume: 35L
rated output hydraulic pressure is 16MPa,
pump type: gear pump
Slot space:25mm
Panel material: aluminum
Workbench type: single side two work station for 2 students
Hydraulic station with hydraulic oil
Whole equipment dimension:1600mm(L)×750mm(W)×1700mm(H)
Aluminum panel dimension: 1200(L)×750(W)
Cabinet:
Experiment that can be finished
Direction control circuit
Hand operated direction valve direction change circuit
Solenoid directional valve direction change valve
Pressure control circuit
Single grade pressure adjust circuit
Secondary pressure adjust
Single grade pressure decrease circuit
Secondary reduce pressure circuit
Use selector valve
Use overflow valve
pilot operated check valve protect voltage
Speed adjust circuit
Oil inlet throttling governing
Back oil circuit throttling governing
By pass circuit throttling governing
Speed adjust valve speed synchronizing circuit
Speed adjust valve parallel circuit
Speed adjust series circuit
Use sequence valve sequent circuit
Use stroke switch control sequent circuit
Use pressure relay control sequent circuit
Use pilot operated check valve single direction lock close circuit
Use pilot operated check valve two directional close circuit
Use “O” type directional change valve close circuit
Relay control hydraulic basic circuit
Hydraulic component capacity measure experiment