Quality Assured
Worldwide Shipping
Expert Support
Split Unit Air Conditioning Training With Cooling Heating System Station Simulation
Description & Specification
Split Unit Air Conditioning Training With Cooling Heating System Station Simulation
Categories:
Refrigeration Training Kit
Technical Specifications
It enables to vary the load conditions of condenser and of evaporator, to use alternative devices for gas expansion, to handle successfully unexpected operating situations, such as the block of the refrigerant flow or a wrong gas charge inside the circuit. This trainer is designed for the in-depth study of vapour-compression cycle. Students can become familiar with the refrigerant pressure-enthalpy diagram and evaluate the heat balances corresponding to the different cycle components, by using the set of industrial instruments of the equipment.
Fan coil unit mounted onto board
Condenser unit mounted onto floor or f the framework
Single phase 220V to 240V, 50Hz
The frame is fitted with heavy duty caster wheels with break
Dust filter, 2 check valves mounted after dryer filters
1 units condenser and 1 units wall hung evaporator
Simulation 10 electrical faults, and 10 test point, contains the following:
Compressor,evap.cond.,thermostat-evap fan, cond fan, H&L pressure, sensor, etc.
The unit is supplied with all material required for installation
Supply all necessary spare parts, installation tools
Floor trap tray
Aluminum (which is better than steel), corrosion resistant outer casting stand.
